FIEM Automatic Humidity with Internal Ultrasonic Nebulizer

When is it needed? If the gutter is cracked, leaking, warped , or no longer fits properly, it should be replaced. A damaged gutter won't maintain the correct water level, compromising humidity and therefore hatching.

💰 Price: €6.50 (VAT excluded, shipping excluded) – FIEM WAREHOUSE COMO

⚠️ ATTENTION: This channel is specific for CIP CIP 40. The CIP CIP 28 model uses different trays (350 TOP).

Minimum order €20: Add thermometer (€22.05), fuse (€0.42) or other spare parts to complete.

📦 Logistics: 1-day shipping, 2-4 day delivery. Warranty: 24 months for private individuals / 12 months for VAT numbers.

A customer from Bassano del Grappa wrote to me: "The quail eggs are drying out, the chicks can't hatch." Checking the photos, the trays were too small (not original). I replaced both with original FIEM 350 TOP trays, and the next hatching went perfectly.

When is it needed? If the tray is cracked, leaking, warped , or too hardened to be cleaned, it should be replaced. The CIP CIP 28 uses two trays : normally one for incubation and both for hatching.

💰 Price: €1.30 each (excluding VAT, excluding shipping) – FIEM WAREHOUSE COMO

⚠️ ATTENTION: This tray is specific for CIP CIP 28. The CIP CIP 40 model uses the 2-compartment channel.

Minimum order €20: Consider getting at least 2 trays + other spare parts (thermometer €22.05, heating element €12.18) to complete.

📦 Logistics: 1-day shipping, 2-4 day delivery. Warranty: 24 months for private individuals / 12 months for VAT numbers.

When is it needed? To check the accuracy of digital sensors in control units, as an independent monitoring tool during critical cycles, to diagnose problems when hatching is not going well, or as the primary tool in incubators without a built-in hygrometer. Essential for breeders seeking a reliable, battery-free monitoring system.

Why the wet bulb method? This principle uses the evaporation of water from a damp cloth to determine relative humidity. It is considered one of the most accurate and reliable methods, with an accuracy of ±3% RH. Unlike digital hygrometers, it does not require power or frequent calibration.

Exclusive Benefits: Specifically calibrated for 37.8°C (incubation temperature), direct reading in %RH without tables, low measurement inertia, no batteries required, extremely accurate for the incubator environment. The set includes a ready-to-use humidifying cloth.

Comparison with a hair hygrometer: The wet bulb hygrometer offers faster response and greater accuracy (±3% vs. ±5-10% for hair). Hair hygrometers are sensitive to wear, dirt, and temperature, require periodic regeneration, and have slow response. For professional incubation, the wet bulb is the more reliable choice.

💰 Price: €24.50 (VAT excluded, shipping excluded) – FIEM COMO WAREHOUSE – Padovan Poultry Farming: professional tools for successful incubation.

Compatibility: Universal - works with any forced-air or still-air incubator

📦 Logistics: Dispatch within 1 business day, delivery within 2-4 days. Warranty: 24 months for private individuals / 12 months for VAT numbers.

💡+ Info? Read the full description below.

Fiem 1.5m tank-float connection tube for semi-automatic humidity control

A customer in Verona incubated pheasant eggs but worked away from home all day: "I come home in the evening and the water has evaporated, I have to open the door every day and lower the temperature." She installed the semi-automatic kit with this 5L tank, and the problem was solved: "Now I fill it once a week."

When do you need it? If you want to convert your incubator from manual to semi-automatic , this tank is the heart of the system. It can also be used to replace a damaged, cracked, or lost tank .

💰 Price: €8.82 (VAT excluded, shipping excluded) – FIEM WAREHOUSE COMO

Complete system: Tank (€8.82) + 97G Float (€5.04) + 10mm Tube (€1.89/m) + Bushing (€0.84) = Automatic humidity kit.

Minimum order €20: Perfect for ordering the complete semi-automatic kit.

📦 Logistics: 1-day shipping, 2-4 day delivery. Warranty: 24 months for private individuals / 12 months for VAT numbers.

Original Spare Parts for Fiem Incubators from Padovan Avicoltura : Ultrasonic humidifier water filter

Ultrasonic humidifier with a single membrane and power supply. It is immersed in the incubator's humidity tray and creates a very fine mist. Thanks to the special socket provided in the incubator/hatcher, the system automatically activates when needed.

ULTRASONIC HUMIDIFIER 1 MEMBRANE + POWER SUPPLY MG432-576-720-400H

LCD HUMIDITY SENSOR + CABLE AND CASE

A pheasant farmer from Vicenza wrote to me: "I have an old MG70 without integrated humidity control. With the hair hygrometer installed, I can finally monitor humidity throughout the cycle. Hatching has improved significantly since I started monitoring this parameter."

When is it needed? For incubators without a built-in hygrometer , as a visual check in addition to the control unit sensor, for continuous monitoring without replacing batteries. The dimensions are designed for the MG and Astrale series holes.

How it works: The hair hygrometer exploits the property of hair (natural or synthetic) to stretch as humidity increases. A system of levers transmits this variation to a hand with a graduated scale in %RH. It requires no electrical power.

Comparison with a wet bulb hygrometer: A hair hygrometer is easier to install (just insert it into the hole) and requires no water or sock maintenance. However, it has a slower response (5-25 minutes vs. a few minutes) and lower accuracy (±5% vs. ±3%). The wet bulb is specifically calibrated for 37.8°C, while the hair hygrometer is generic. For precise professional monitoring, we recommend the wet bulb; for practical, maintenance-free monitoring, the hair hygrometer is excellent.

📦 Logistics: Dispatch within 1 business day, delivery within 2-4 days. Warranty: 24 months for private individuals / 12 months for VAT numbers.

💡 More info? Read the description below.

PG9 IP66 cable gland

Original Spare Parts for Fiem Incubators from Padovan Avicoltura : Stainless steel splash guard cover 14x9 cm for F02 tray

Fiem kit to add a humidifier socket for the Mini LED and Mini LCD models without

The kit includes an IEC socket, power cables, and fastons. This work must be performed by a qualified electrician.

Constant and professional humidity control with the FIEM Limpia 4-liter humidifier

Designed to optimize humidity management during incubation, the FIEM Limpia ultrasonic humidifier is the ideal choice for those seeking precision, silence, and automation. Thanks to its nebulization system, it ensures a uniform supply of cold steam within the incubator chamber, improving the embryonic development environment and hatching rates.

Perfect for integration with FIEM incubators equipped with a digital control unit for automatic humidity regulation. The 4-liter tank ensures autonomy and operational continuity.

Positive reviews online : Reliable, precise, compact, and quiet. Also appreciated for its easy connection to the compatible Evo Plus and Mini LED Advanced models.

Criticisms found on the web: Some users recommend using only distilled water

A customer wrote to me: "The wet-bulb hygrometer always read 100% even when the incubator was dry. I replaced the sock, which was encrusted with limescale and dirt, and now it works perfectly again. My mistake: I was using tap water instead of distilled water."

⚠️ CAUTION - CRITICAL MAINTENANCE: The muslin sock is the most important component for the proper functioning of the wet bulb hygrometer. It MUST be replaced frequently and ALWAYS kept moist with distilled water. A dirty, dry, or mineral-encrusted sock will cause completely incorrect readings.

When to replace: With each new batch of eggs, when the sock appears dirty/yellowish, if there are white scale deposits, when the readings are unstable or stuck at 100%, or if the sock no longer absorbs water well. ALWAYS use distilled or demineralized water to avoid mineral deposits.

What's included: 1 meter of cotton muslin wick, enough for several refills. Cut to the length needed to completely wrap the thermometer bulb.

Basic rules: The sock must always be kept moist, use only distilled water, tighten it well around the bulb, make sure it sits properly in the water tank.

💰 Price: €2.00/meter (VAT excluded, shipping excluded) – FIEM COMO WAREHOUSE – Padovan Avicoltura: original spare parts for precision instruments.

Compatibility: FIEM HNB wet bulb hygrometer and Fiem thermohygrometer

📦 Logistics: Dispatch within 1 business day, delivery within 2-4 days. Warranty: Consumable product.

💡 More info? Read the description below.